Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Borough Park
If the cap on your Borough Park chimney has rusted loose or the crown has cracked and pulled away from the flue, you’re looking at a top-of-stack repair, not a cleaning. We handle chimney cap and crown work across Borough Park, from 13th Avenue to the blocks around 50th Street, and we know what’s usually under those caps: gas boilers and water heaters vented into original coal-era flues, not wood fireplaces. That changes how a cap and crown job gets diagnosed. Call (866) 937-8201 and we’ll set a time. The estimate is free, and nothing gets recommended until you’ve seen the camera footage yourself.

Why Borough Park Homeowners Call Chimney Sweep Sunset Park for Chimney Cap & Crown
Chimney work in Borough Park draws a lot of low-bid sweepers who brush a flue and leave, then hand you off to someone else when the crown turns out to be the real problem. We don’t work that way. Our technicians have up to 11 years of experience, and the people who inspect your stack are the same people who set the cap and rebuild the crown, so nothing gets subcontracted out mid-job.
What matters more here is proof. A crown repair is easy to sell by fear and hard to verify from the sidewalk, and this neighborhood has heard both pitches. Our answer is a camera. We run a Level 2 inspection, show you the spalling brick, the open flue tile, the cracked mortar on screen, and we tell you plainly when a repair can wait a season.
We also come with the right materials. We source and install professional-grade brands like Gelco and Copperfield because a cap that fails in five years costs more than the difference, and we say so. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Borough Park
Cap Installation
A new cap belongs on any Borough Park stack that’s open to the sky, and most are. On a rowhouse or walk-up here, the cap has to be sized to the actual flue tile, not approximated with a universal lid, or rain still gets in and animals still get down. We measure, then install a cap that closes the top without choking the draft a gas boiler needs.
Cap Replacement
Rusted-out and missing caps are the most common thing we find on Borough Park roofs, especially on shaded north-side stacks and party walls where moisture sits. A failed cap lets rain straight down an unlined or clay-tile flue that now vents a boiler, so water reaches the appliance and the draft complaints follow. We pull the old cap, check the flue condition below it, and replace it with the correct size.
Crown Repair
The crown is where Borough Park chimneys fail hardest. Century-old mortar cracks and separates from the flue tile at the top of a party-wall stack, then moisture wicks into the brick, spalls it, and drops mortar down into the flue. We rebuild the crown with a proper slope and bond so water sheds away from the flue instead of into it.
Crown Coating
Not every crown needs to come off. When the structure is sound and the cracking is surface-level, a crown coating seals the mortar and buys the stack real years. We only recommend coating when the camera and a close look at the crown say the base is solid, and we’ll tell you when it isn’t.
We also install multi-flue and custom caps for Borough Park buildings with more than one appliance on the same stack, which is covered further down this page.
Trusted Brands We Service in Borough Park
We name the brands we install, because the materials matter as much as the labor. For cap and crown work in Borough Park we work with Gelco, Copperfield, Olympia Chimney and Famco, all professional-grade lines rather than hardware-store generics. We don’t claim to keep a warehouse of parts in Borough Park, and we don’t need to. We spec the cap or crown coating to your stack, source it, and set a turnaround that matches the job. If your existing cap or crown is one of these brands, we can work with it or tell you plainly when it’s past saving.

Common Chimney Cap & Crown Problems We See in Borough Park Homes
- Rusted or missing caps over appliance flues. When the cap is gone or rusted through, rain runs straight down a flue that now serves a gas boiler or hot-water heater, and the first symptom is usually weak draft or a smell, not anything fireplace-related.
- Cracked crowns on party-wall stacks. The dense brick construction in Borough Park holds moisture, so crowns crack and separate from the flue tile, and the shaded north side and party walls spall first. Mortar dropping into the flue is often the first visible sign.
- Two appliances on one original coal flue. A boiler and a water heater sharing one century-old stack backdraft under a loose or undersized cap, and CO complaints get blamed on the boiler when the top of the stack is the real problem.
- Oversized or universal caps on clay-tile flues. A cap that doesn’t fit the tile lets weather in around the edges and restricts draft at the same time, which is the worst of both on a 3- or 4-story walk-up.
Why Borough Park’s Older Chimneys Fail Differently
Most of what sits under a Borough Park cap is not a fireplace. It’s a gas boiler or hot-water heater tied into an original coal-era flue, and often two appliances on one stack. That’s the local tell: in much of the neighborhood, a failed crown or a missing cap shows up first as draft trouble and CO alarms rather than as anything a homeowner would call a chimney problem. The masonry backs it up. The 1900s-1930s brick rowhouses and 3-4 story walk-ups, with rear extensions and shared party walls, have stacks on the shaded north side that hold moisture and spall through New York’s heating season, when boilers run hard from November through March.
On a typical Borough Park rowhouse or walk-up, the boiler and water heater share one original coal flue, and the cap on top has rusted loose or the mortar crown has cracked and pulled away from the flue tile. Rain and meltwater run down the flue, the boiler’s draft weakens, and someone in the building notices a smell or a CO alarm. A qualified local sweep runs a Level 2 inspection with a camera, shows the homeowner the spalling crown and the open flue on screen, then sets a properly sized multi-flue or custom cap with a rebuilt or coated crown and correct flashing so the stack is closed to weather and animals. That’s the whole job, and you should be able to see every part of it before you agree to it.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Cap & Crown in Borough Park, NY
Cap and crown work in Borough Park is priced per job, and the written estimate sets the final number. Typical ranges for the neighborhood look like this: a standard cap installation runs about $225 to $475; a multi-flue or custom cap for a building with more than one appliance on the stack runs about $450 to $1,100; a crown repair with a rebuild runs about $600 to $1,600; and a crown coating runs about $350 to $750. Height, roof access, the number of flues, and whether the crown is surface-cracked or structurally separated all move the number. We give you the range up front, then confirm it after the inspection, with the camera footage in front of you. Estimates are free.
We Also Serve Cities Near Borough Park
Borough Park sits close to several neighborhoods where we handle the same cap and crown work, including Sunset Park, Kensington, Dyker Heights and Bensonhurst. The building stock and the appliance-venting flues are similar across all of them, so the same camera-first approach applies. If you’re in Borough Park and wondering whether your across-the-line neighbor’s repair looks like yours, it probably does, and we can tell you why.
Serving Borough Park, NY – Our Local Coverage Area
We serve Borough Park and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Borough Park
Yes, in most cases a multi-flue cap is the right fit when two appliances share one original coal flue, because it closes the whole stack to weather without choking either appliance’s draft. A single small cap over one tile leaves the other opening exposed. We measure the tile layout and spec a cap that covers both correctly. Call (866) 937-8201 for an exact quote; estimates are free.
Spalling brick at the top of a Borough Park rowhouse chimney is usually a crown problem first, with the flue affected if water has been running down it long enough. A cracked crown lets moisture into the brick, which spalls and drops mortar into the flue. The camera tells you which one you have and how far it’s gone. Call (866) 937-8201 and we’ll get it looked at.
You know because you see it. We run a Level 2 inspection with a camera, show you the cracked mortar, the separated flue tile and the spall on screen, and we tell you when a repair can safely wait a season. Nothing is recommended without camera evidence you can look at yourself. Take a look first, then decide. Call (866) 937-8201 for an exact quote.
Yes. A cap matters more, not less, on a boiler flue, because rain running down an unlined or clay-tile flue reaches the appliance and weakens draft, and animals and debris block the vent. Borough Park’s dense masonry makes moisture the main enemy on these stacks. Call (866) 937-8201 and we’ll check the cap, then quote it straight.
A Level 2 inspection shows you the inside of the flue and the condition of the cap and crown on camera, so you can see the spalling, the cracks and any open flue on screen. On a Borough Park stack it also reveals whether two appliances are backdrafting on one coal-era flue. That’s the evidence behind every recommendation we make. Call (866) 937-8201 to book it; the estimate is free.
Get Your Borough Park Cap and Crown Checked
If your cap is rusted, your crown is cracked, or you’ve had a draft or CO complaint in the building, call us and we’ll look at it properly. Call (866) 937-8201. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. The estimate is free, and our chimney cap & crown team handles the whole job, from camera inspection to the finished crown. A clean flue is the starting point. A safe, structurally sound chimney is the goal.
Written by the team at Chimney Sweep Sunset Park.