Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Trusted Chimney Sweep for Sunset Park Homeowners
If your fireplace has been burning all winter and you haven’t had the flue cleaned, you’re probably sitting on a layer of creosote that’s thicker than it looks from the hearth. The real problem isn’t the mess – it’s that soft, flaky creosote near the top of the flue can catch a spark and start a chimney fire you won’t hear. A proper sweep clears it, a proper inspection tells you whether anything else needs attention, and both happen in the same visit in Sunset Park.
Our technicians have up to 11 years of experience, and they don’t just run a brush through the flue and leave. We check the firebox, damper, smoke chamber, cap and crown while we’re there, and we’ll tell you plainly if the chimney is in good shape or if something needs fixing. The local pro we connect you with is licensed and insured as New York State requires. Call (866) 937-8201 and we’ll book your sweep.
Key Takeaways:
- We clean, inspect, and repair – not just sweep.
- Camera inspection and a photo report included with every visit.
- HeatShield and DuraFlex materials on hand for repairs that turn up.
- Nothing gets recommended unless you can see the evidence yourself.
What Our Chimney Sweep Service Includes
Every sweep is a full system check, not a brush-and-go. Here’s what each piece of the work actually covers, and when you’d need it.
Level 1 Inspection
A Level 1 is the standard annual inspection you get with a routine sweep. It covers all the readily accessible parts of the chimney and venting – the firebox, damper, flue, and the visible parts of the exterior – using a camera where we can’t see directly. If you’ve never had your chimney looked at, or it’s been a while, this is where to start.

Level 2 Inspection
A Level 2 goes further, including the parts of the flue that aren’t visible without a camera. You need one when you’ve changed fuel types, after a chimney fire, after a building change near the chimney, or when you’re buying or selling a house in Sunset Park and need documentation. We run a camera the full length of the flue and give you a photo report you can keep.

Creosote Removal
Creosote builds up in three stages – soft and flaky, then crusty and glazed, and glazed creosote is the dangerous kind. A standard sweep clears the soft and moderate stages; glazed creosote needs chemical treatment or a rotary tool before it can be removed. We assess which stage you’re in during inspection and treat accordingly, rather than telling you a brush-out will fix something it can’t.

Soot Removal
Soot is the fine, powdery residue that settles on the smoke chamber walls and the top of the firebox. It doesn’t burn the way creosote does, but it restricts the flue’s draft and it makes a mess the moment you open the damper. We vacuum and wipe those surfaces as part of the sweep so the smoke goes up the flue where it belongs.
Annual Sweep
An annual sweep keeps the flue clear before the heating season starts, and it’s the single best guard against a chimney fire. If you burn hardwood regularly, once a year is the benchmark; if you burn a lot of softwood or you burn often, you may need more. We book these seasonally, and it’s worth doing it before the first cold snap rather than after.
Fireplace Cleaning
Beyond the flue, the firebox, grate and hearth take on ash, soot and creosote staining over time. A deep clean brings the fireplace back to something you’d actually want to sit in front of, and it lets us check the firebrick and mortar for cracks that weren’t obvious under the ash. If you’ve just moved into a Sunset Park home with an open fireplace that hasn’t been used in years, this is the first call to make.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Brands We Service for Chimney Sweep
We name the brands we install and work with, because the materials matter as much as the labor. HeatShield is the one we lean on most for flue resurfacing – it’s a repair-grade product that lets us restore a compromised clay liner from the inside rather than tearing it out. DuraFlex flexible liner systems are our go-to for full liner replacements, measured from the cap down so the fit is right the first time. Both are professional-tier materials, not hardware-store generics.
On the cap and crown side, we work with Gelco and Olympia Chimney – Gelco for caps and dampers, Olympia for liner components and caps that hold up to wind and weather on a rooftop. Understanding where each one wears out, and which one is the right choice for a given chimney, is what separates a real repair from a patch. Whether your chimney has HeatShield, DuraFlex, Gelco, Olympia Chimney or any other make, we can help.
Signs You Need Chimney Sweep Right Now
- A strong, sharp smell from the fireplace. That acrid, smoky odor on a damp day usually means creosote buildup and poor draft. It’s not just unpleasant – it’s telling you the flue is restricted.
- Smoke rolling back into the room. A chimney that used to draw fine but now puffs into the room has a blockage or a draft problem. Don’t keep burning until it’s diagnosed – the smoke is going somewhere, and it isn’t up.
- Black, flaky buildup visible at the top of the firebox. Creosote you can see is creosote that’s ready to catch a spark. Have it cleaned before you run the fireplace again.
- Debris, leaves or animals in the flue. A nest or a pile of leaves shuts off your draft completely. This is a safety issue, not a cleaning inconvenience.
- It’s been more than a year since your last sweep. If you can’t remember the last time it was cleaned, that’s your answer. Annual sweeps are the benchmark, and skipping them is how small problems become expensive ones.
Our Chimney Sweep Process – Step by Step
- 1
Walkthrough and drop cloths. We set up floor protection before anything comes out of the fireplace, and we look over the firebox, damper and hearth with you so you know what we’re seeing.
- 2
Camera inspection. A camera goes the length of the flue so we’re working from evidence, not guesses. Anything we flag, we show you on the screen right there – nothing gets recommended without a picture you can see for yourself.
- 3
Cleaning. We sweep the flue, then clear the smoke chamber, firebox and damper with HEPA-filtered vacuum equipment, so nothing drifts back into the room.
- 4
Assessment and photo report. We check the cap, crown and mortar joints on the roof, and put together a photo report of what we found. If there’s a repair needed, you’ll see exactly why.
- 5
Results and options. We walk you through what we found and what needs attention, in plain language, with a written estimate for anything beyond the sweep. You’ll also hear it from us if the chimney is fine and the work can safely wait.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Sweep Cost in Sunset Park?
A standard chimney sweep in Sunset Park typically runs $150 – $250 depending on the number of flues, access to the roof, and how much buildup there is. A Level 1 inspection bundled with the sweep commonly lands around $175 – $300, while a Level 2 inspection with a full camera run generally runs $250 – $450. Fireplace cleaning as a standalone typically comes in around $125 – $225.
| Service | Typical Range |
|---|---|
| Standard sweep (single flue) | $150 – $250 |
| Sweep + Level 1 inspection | $175 – $300 |
| Level 2 inspection with camera | $250 – $450 |
| Fireplace deep clean | $125 – $225 |
| Glazed creosote treatment | $300 – $600 |
What moves the price is the number of flues, roof access and pitch, the condition of the creosote, and whether you need a Level 2 for a real-estate transaction. You avoid overpaying by getting the inspection and the sweep in one visit – a separate trip for the inspection costs more than bundling it. The estimate is free, the price is set per job by the written estimate, and nothing gets added without camera evidence you’ve seen. Call (866) 937-8201 for an exact quote.
Chimney Sweep Near Sunset Park – Our Service Area
We work throughout Sunset Park and the neighborhoods around it, including Borough Park, Kensington, Bay Ridge, Dyker Heights, Carroll Gardens, Red Hook, Park Slope, Flatbush, Bensonhurst, Midwood and Prospect Heights. If you’re in one of those areas, a chimney sweep can usually be booked within a few days, and we schedule early. If you’re nearby and want the full picture of what we do, start with our Chimney Sweep Sunset Park page.
Serving Sunset Park, NY – Our Local Coverage Area
We serve Sunset Park and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Chimney Sweep in Sunset Park
A chimney sweep is a professional cleaning of the flue and firebox to remove creosote, soot and debris. It’s paired with an inspection so you know the chimney’s condition, not just that it’s cleaner. We do both in one visit, with a camera and a photo report.
A standard sweep usually takes 45 minutes to an hour for a single flue. If we add a Level 2 camera inspection or glazed creosote treatment, expect 90 minutes to two hours. The time you spend is the visit, not the sweep alone.
A typical sweep runs $150 – $250, and a Level 2 inspection with it generally lands between $250 – $450. The written estimate sets the final price, and the estimate is free. Call (866) 937-8201 for an exact quote.
Yes – both are materials we install and work with regularly. HeatShield is our flue resurfacing product and DuraFlex is our full flexible liner system, so a sweep that turns up a compromised liner can be handled without a second contractor. We also work with Gelco and Olympia Chimney for caps and liner components.
Same-day sweeps are often possible depending on the day’s schedule. We answer 24/7, and fast dispatch runs 7am to 7pm, Sunday through Friday; we’re closed Saturday. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm.
Yes – our work is backed by a satisfaction guarantee. If something isn’t right after the visit, we’ll come back and make it right. The local pro is also licensed and insured as New York State requires.
Clear the hearth and the floor in front of the fireplace, and move anything breakable out of the immediate area. Don’t use the fireplace for at least 24 hours before the sweep so the creosote is cool and settled. If your damper is stuck or you suspect a blockage, tell us when you book so we can plan for it.
Schedule Your Chimney Sweep Service in Sunset Park Today
Don’t wait until the first cold night to find out your flue needs attention. Book a sweep and inspection now, get a free written estimate, and know exactly where your chimney stands before burning season. Call (866) 937-8201 to schedule – we answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. For a chimney sweep in a neighboring area or a related job like cap and crown work, our team can help.
Written by the team at Chimney Sweep Sunset Park.