Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Fireplace Repair Across Crown Heights
If your fireplace smells like smoke when it’s cold outside, or a damper won’t seal, or the mortar in the firebox is dropping crumbs onto the hearth, the fix is rarely cosmetic. In Crown Heights, it almost always traces back to how these chimneys were built. Most of the housing stock here dates to roughly 1890 to 1935: two- and three-story brick rowhouses and brownstones with original fireplaces, coal-conversion flues, and stacks that were never lined to modern standards. We bring a camera, and we show you what we find before we quote anything. Nothing is recommended that you can’t see for yourself.

Our technicians have up to 11 years of experience, and we handle fireplace repair as part of the full chimney system, not as a side job. Call (866) 937-8201 for a free estimate.
Why Crown Heights Homeowners Call Chimney Sweep Sunset Park for Fireplace Repair
We get called to Crown Heights for the same reason people call us across our service area: someone cleaned the flue, swept away the soot, and never looked at the liner. On the older rowhouses along the blocks near Eastern Parkway and the buildings off Kingston Avenue, the problem sits deeper than creosote. Flues built in the 1920s and 1930s were often clay tile or, in some cases, bare brick with no tile at all. Behind original plaster, offset flues turn where a camera can’t see from the damper. That hidden geometry is where smoke backs up and heat transfers. We diagnose it with footage.
Homeowners here call us because we name the brands we install. We source and install DuraFlex stainless liners, HeatShield flue resurfacing, Olympia Chimney components, and Famco dampers depending on what the flue actually needs. That matters when the recommendation is structural, not just a cleaning.
Response to Crown Heights is straightforward. We answer 24/7, and we dispatch Sunday through Friday, 7am to 7pm. We’re closed Saturday. A call outside those hours is booked into the next opening. If you’re on a brownstone block, tell us your building and neighbors’ arrangement when you call, because shared stacks change the plan.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Fireplace Repair Services in Crown Heights
Fireplace problems here fall into a handful of categories, and each one has a different right answer. Here’s how we approach the four most common calls in Crown Heights.
Gas Fireplace Repair
Gas inserts and logs in Crown Heights often feed into chimneys that were built for wood and later converted. That mismatch means the vent geometry matters as much as the burner. We check the flue connection, the pilot assembly, and the smoke chamber above the damper. We don’t leave a gas appliance venting into a stack we haven’t inspected.
Wood Burning Fireplace Repair
Wood fireplaces in these rowhouses need the firebox, damper, smoke chamber, and flue checked together. A crack in the firebox brick can let heat reach framing behind it. We repair firebox joints, rebuild masonry where it’s failed, and parge smoke chambers where the original plaster has broken down. Each recommendation comes with camera evidence.
Fireplace Insert Service
Inserts are common in Crown Heights because they recover heat from flues that lose it through shared masonry walls. An insert installed without a proper liner can vent into an oversized flue, which causes draft problems and creosote accumulation. We assess the liner, the surround seal, and the damper connection.
Damper Repair
A damper that won’t close, won’t open smoothly, or has rusted into place is one of the first things we check. In these old fireboxes, the damper sits above a smoke chamber that’s often parged and sometimes failing. We repair or replace dampers with Famco components, then verify the seal.

Trusted Brands We Service in Crown Heights
We work with professional-grade materials from DuraFlex, Olympia Chimney, Famco, Copperfield, HeatShield, and Gelco. These are the same product lines restoration and commercial contractors use, not hardware-store generics. We don’t claim to stock anything on a truck. What we do is measure, order, and install the right component for the flue we’ve diagnosed, and we handle the delivery timing with you. From the firebox to the crown, the work stays with one team. We diagnose before we quote, and we don’t add parts to a written estimate after it’s signed.
Common Fireplace Repair Problems We See in Crown Heights Homes
- Unlined or failing clay-tile flues. Many 1920s and 1930s stacks here never got a modern liner, and the original tile joints have deteriorated over the decades. Creosote collects in the gaps, and heat can reach adjacent wood framing. A camera run is the only way to see it.
- Shared chimney stacks between adjoining units. On original brownstone blocks, the stack is often one masonry structure serving two fireplaces. A repair on one side can reveal mortar or liner failure on the neighbor’s flue. That’s a two-owner conversation, and we help coordinate it.
- Freeze-thaw damage to crowns and brick. Winters here cycle above and below freezing repeatedly, which cracks mortar crowns and spalls brick. Water gets into the chimney, degrades the smoke chamber, and reaches the damper. Summer humidity then keeps creosote glazed and harder to remove, so spring and fall sweeps tend to surface different problems.
- Fireboxes rebuilt with the wrong materials. Some older fireboxes here were patched with mortar that doesn’t handle heat. It cracks within a season. A proper repair uses refractory materials suited to the firebox, not standard mortar.
See the difference
Before
After
Before
After
Before
AfterPricing for Fireplace Repair in Crown Heights, NY
Fireplace repair in Crown Heights is priced per job from a written estimate, and the estimate is free. Typical ranges give you a starting point: firebox repair commonly runs $450 to $1,200 depending on how much brick or parging has failed; damper repair or replacement is usually $250 to $650; HeatShield flue resurfacing typically runs $1,800 to $3,500; and a full DuraFlex stainless liner installation commonly runs $2,800 to $5,500, driven by flue height and the number of offsets.
What moves the number: access to the flue from the roof, whether the smoke chamber needs parging, and whether the firebox requires partial rebuild. On shared stacks, both sides sometimes need scope so each owner knows what’s theirs. We put all of it in writing before anyone books.
We Also Serve Cities Near Crown Heights
Fireplace repair covers more than Crown Heights. We work in Prospect Heights, Flatbush, Clinton Hill, and Park Slope, plus the surrounding blocks. If you’re on a block where the rowhouses run together, the same shared-stack logic applies in these neighborhoods too. Tell us your building when you call and we’ll tell you what we need to bring. More on our Crown Heights service area.
Serving Crown Heights, NY – Our Local Coverage Area
We serve Crown Heights and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Fireplace Repair in Crown Heights
Sometimes yes, but not until it’s been inspected with a camera. An unlined brick flue in a 1920s or 1930s Crown Heights stack can function if the brick is sound and the joints haven’t eroded, but that’s a camera call, not a guess. If we find gaps or exposed framing, the safe path is relining with HeatShield or a DuraFlex stainless liner before you burn again. Call (866) 937-8201 for a free estimate.
Responsibility depends on the building’s structure and any agreements between owners. In Crown Heights rowhouses, the stack is often one masonry structure serving two fireplaces, and the portion above the roofline may be joint property. We inspect both sides when asked, show each owner the footage, and put findings in writing so each party can make an informed decision. Call (866) 937-8201 to set up an inspection.
Crumbling mortar, loose brick, cracks in the firebox walls, or a white chalky residue are the usual signs. In Crown Heights, the freeze-thaw cycle and water intrusion from cracked crowns tend to accelerate firebox deterioration. If you can see missing mortar or feel loose brick by hand, stop using the fireplace and have it looked at. Call (866) 937-8201 for a free estimate.
Yes. We service gas inserts, gas logs, and converted fireplaces, including pilot light issues, thermocouple and thermopile problems, burner and valve faults, and venting concerns. What we won’t do is repair a gas appliance that’s venting into a flue we haven’t inspected. Call (866) 937-8201 to book service.
First-degree creosote is soot and light flake that a standard sweep removes. Third-degree is glazed, hardened creosote that’s bonded to the flue wall and requires chemical treatment or mechanical removal, sometimes flue resurfacing. In Crown Heights, humid summers and wood-burning habits can push buildup toward the glazed stages. Glazed creosote is a fire hazard and won’t brush off. Call (866) 937-8201 for an inspection.
What Happens When You Call
Call (866) 937-8201. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. We book a diagnostic visit, run a camera through your flue, show you the footage, and put the recommendations and prices in writing. If your Crown Heights fireplace can safely wait, we’ll tell you that too. Estimates are free, and nothing gets scheduled without your go-ahead.
Written by the team at Chimney Sweep Sunset Park.